Software Information

The PSDUM driver software is designed to run on a variety of Mobile Computers using the Windows Mobile and CE operating systems.  Portsmith certifies and supports as many manufacturers and models as possible.  Additional devices are tested regularly, and Portsmith will test additional devices at no cost to a Reseller or Manufacturer.  If you have a device you would like to have tested please contact sales@portsmith.com.

Requirements

USB Host

  • The PSDUM driver is designed to work on a handheld that has Host USB capabilities.
  • Manufacturer specifications usually indicate if the device has a USB “On The Go” (OTG) or “USB Host” capability.

Operating System

  • Windows CE 5.0,  6.0
  • Windows Mobile 5.0, 6.0, 6.1, 6.5

Disk Space

  • 100 KB disk Space

PSDUM Installation

Download the appropriate version of PSDUE specified in the individual Product Page (Your browser may warn you about potentially dangerous software).  Copy it to your device using ActiveSync or removable storage such as MicroSD and SD Cards supported. Windows Mobile Copy the proper CAB file to your device using SD Card or ActiveSync and then install as shown below.

Select CAB file

Pick installation location.

Reboot when prompted.


.

Windows CE Copy the proper CAB file to your device using SD Card or ActiveSync and then install as shown below.

Select CAB file.

Select Location

Reboot as directed.


.

Setup a Connection

After installing the modem software, you need to create a connection that will use the Portsmith USB Modem.  To create a connection, follow these steps. Windows Mobile Under Start -> Settings -> Connections -> Connections, select “Create new connection”.

Add New Connection

Select Portsmith USB Modem

Enter phone number.

Enter username and Password

Connection Created


.

Windows CE Click on Start -> Network  and Dial-Up Connections and select “Make a New Connection”.

Select Dial-UP Connection

Select Portsmith USB Modem

Enter phone number.

New Connection Completed


.

Additionally, you may need to set the Internet Options to use this connection for Auto-Dial. This can be done in the Control

Panel under “Internet Options”.